CRL 5/16" Hole; 1-3/8" Length Diamond Plastic Anchors Quantity:Pack of 100 minimum order 100 pair

minimum order 100 pair

These CRL Plastic Cross-Cut Trim Snips have a high impact molded plastic base that gives an accurate 2" (51 mm) wide 90 degree cross-cut every time

Water and dust protection: IP54

Available in six standard sizes in grits from 36X (Super Coarse) to CORK (Polishing) to fit most any upright belt sanding machine

This captures the abrasive into the hood and returns it to the tank

CRL 5/16" Hole; 1-3/8" Length Diamond Plastic Anchors Quantity:Pack of 100 minimum order 100 pairUse in Concrete, Block, Brick, and Wallboard Use with Either Wood or Sheet Metal Screws Available in Three Sizes Use these CRL Diamond Plastic Screw Anchors with either wood or metal screws. Their flat, concentric ribs resist turning and give a greater bearing surface for stronger holding power. An open slot permits inner end compression for easy insertion and expansion. Product images shown are of the actual product or a close representation. Colors